)
ECOProbe Soil Gas Monitoring and Modeling
Home » ECOProbe Soil Gas Monitoring and Modeling
EcoProbe 5 3D Soil Gas Monitoring and Modeling
The Ecoprobe 5 can verify soil gas concentrations in landfill caps or help you model your contaminant dispersement plume for the entire site in one day or less! Used for; Detection, delineation and monitoring of hydrocarbon and other organic contamination of soils, and/or water table from fuel spills, Fast and convenient monitoring of UST and pipe-lines for leakage, Waste dumps & agricultural waste measurement, Monitoring of contaminant plume migration, Monitoring of in-situ bio-remediation processes, Selective Detection and monitoring of Methane effluence over closed coalmines, Detection and monitoring of gaseous toxins in industrial plants and agriculture, Detection and monitoring of contaminant effluents from various fittings sealing in chemical/petrochemical industry. Meets EPA 21 standards, and Air pollution monitoring.
Downloads
Product Description
The ECOPROBE 5
Simultaneous in-situ measurements using the time integrated photo-ionization analyzer (PID) and infra-red analyzer (IR).
PID (Photo-ionization analyzer)The PID measures total level of volatile organic compounds (VOCs) and other toxic gases including chlorinated hydrocarbons to sub-ppb levels. Calibration for 200 compounds inside the unit.
IR (Infra-red analyzer) cell Comprise 4 independent channels for selective analyses of Methane, Petroleum Hydrocarbons and CO2 with ppm resolution (50 ppm detection limit 0.
And internal measurements for;
Oxygen, 0-100 %
Soil temperature: deg. F,C; (+/- 0.1C, resolution 0.01C)
Sampled gas temperature: deg. F, CAmbient pressure / sampling vacuum (mbar, Torr, psi, kPa), accuracy 0.1%, resolution 0.01%
Real time correction of measured values for soil porosity, atmospheric / pumping pressure Estimate of Soil Permeability
Also packaged is a fully integrated automatic GPS Position Logger (up to centimeter accuracy) which is referenced to the WGS 84 coordinate system and also supports surface format "in meters" for un-demanding operator navigation.IrDA/RS232 interface with Win9x/NT4.0 /2000 compatible ECOPROBE_VIEW software, providing data transfer and fast visualization. Measured data are stored according to time; exports any data table with coordinates in the world geodetic format WDS 84 without affecting accuracy. Data Format: ASCII, EXCEL, GRAPHER, SURFER or user programmable format. Automatic date/time record for all stored data, built in adjustable acoustic alarm for all measured values. Communication software Ecoprobe Plus enables Customer Multipoint Advanced Calibration (for virtually any gas within detection range) and full remote control and operation via direct Internet (Ethernet RJ45 socket) or GSM connection. Remote manufacturer's check, calibration and software upgrade available via Internet.
Remote Monitoring & Continuous Monitoring Ability.Ecoprobe 5 can be used to operate automatically as a monitoring station. You can just preset parameters in Monitoring Station Configuration File and leave the instrument anywhere needed without need to connect electricity or communication line.
The Ecoprobe 5 will work for you!